Bob, yeah I saw there was the other type of tray. I went with the one I have as that's the info I was able to find for making one. Plus I was able to use an original cover.
I ended up making the hold down rods myself. Welded the rod onto a plate then ground it down to make it look like it had been forged. The ran a die to thread the ends. The picture with the tray shows the rods attached via screws. I went back and riveted them on properly.
The last picture is the new wood stiffener I had made to replace my slightly eaten original. I painted two coats of Por15 on sanding in between. It gave a rock hard finish that will hopefully keep the bugs and moisture out of it for many years to come.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
|