[Darrin Wright]

Here are some detailed shots of the conduit that may assist others.

I have the wiring and conduit completed, the dash is wired up. I have installed a fuse block and loom connectors to assist with installation & removal of the dash (there is a lot of wire back there!).
Installed a new voltage regulator.

Have completed a lot of small and not so small jobs.
Radiator has had the top tank repaired and re-installed, cooling system filled.
Battery installed and circuit testing done (several times). Don't want to melt something.

Installed new fan belts, B-53, and adjusted the generator. I had to manufacture a 4mm spacer plate for the fan blades as they were too close to the distributor and coil plate. They sit in the shroud fine.

I have had the fuel tanks TIG welded- ends installed and plates installed. Today I spent several hours washing and preparing the fuel tanks for POR-15 fuel tank sealer, sealed the tanks and they are currently drying for the next 3 days. Will paint them green in the next day or 2.