[Lionelgee]

Hello All,

How are you at old engine identification?

I have been offered the chance to take away an old motor. It looks like the front section of its old chassis was made into a frame for a stationary motor. It used to be hooked up to a water pump on a farm.

My apologies for the quality of the two photographs. It looks like there is a dog for a crank start on the front of the motor and a hole going from the front frame and radiator support.

Any ideas? I can visit the pump for some better photographs if these ones are too bad to be of any help.

There is no visible name written on the radiator or the engine block.

Then again there could be if I knew where to look!

Kind Regards
Lionel