[Private_collector]

Hey there Andy,

I want to do three rows on the rear canopy. That will be the most difficult part. Mrs B will help with the manoeuvring of all that canvas, as it goes past the sewing point.

All the other parts shouldn't be too difficult (how's that for naive), as there will not be two rows required.

The three rows will be, one row stitched with both pieces facing inwards, then one stitch each side of the one just done, after the canvas has been opened facing outwards. So long as I follow the original stitch line, either side, that SHOULD guide me. Optomism Bourne from ignorance possibly.

I couldn't resist trying the machine again yesterday, putting into effect the pointers and advice I had been given. Although I still don't have the thread feed pressures correct, I did manage to get some sound sewing. While adding tension to the upper thread, I found a very fine line between crappy stitching and broken thread. The latter being most common result. Not too worried about that, because once I get the heavier thread, that problem should disappear.

Incidentally, I found yesterday that the heavy duty needles I have bought do NOT fit the machine. They are thicker where they insert into the area that locks them into place. It's an easy fix, but requires a replacement Needle Bar to fit them. I have ordered one, for $10, and it will be arriving next week. Then I will have to figure out how to change it over. That could be 'fun'. The manual is somewhat lacking in detail, and doesn't show that job at all. Can't be harder than rebuilding a transfer case, so I will learn as I do it.