There were two types of regulator housing. The one with clamp around the center is the T-16 early pattern. Latter looks just like those used in a jeep but it has higher capacity guts being 12v 55amp which were the same as found on the U.S. half-tracks.
Vintage Power Wagons in the USA produced electronic replacement guts to fit the regulator housings. Not sure if they still make them or not but it's what I had in my carrier.
http://www.mapleleafup.net/forums/showthread.php?t=9136 Message #161 in my old carrier restoration thread shows the later style regulator housing for reference. Guts should fit in either housing though since its a digital circuit board.
__________________
David Gordon - MVPA # 15292
'41 Willys MB British Airborne Jeep
'42 Excelsior Welbike Mark I
'42 BSA M20 Motorcycle
'43 BSA Folding Military Bicycle
'43 BSA M20 Motorcycle
'44 Orme-Evans Airborne Trailer No. 1 Mk. II
'44 Airborne 100-Gallon Water Bowser Trailer
'44 Ford T-16 Universal Carrier
'44 Jowett Cars 4.2-Inch Towed Mortar
'44 Daimler Scout Car Mark II
'45 Studebaker M29C Weasel
Last edited by Hanno Spoelstra; 01-12-15 at 09:11.
Reason: corrected link to message #161
|