Quote:
Originally Posted by Private_collector
On another topic. Does anyone have first hand experience with installing the Ford flathead engine and gearbox WITHOUT removing the cab????? I would very much like to get my cab back onto the chassis without further delay. The only thing preventing me is of course the unfinished engine rebuild. If it can be put in carefully, with success, it will get me some more workshop space that I intend to use for my sewing machine. It is currently in the other shed, and in the way there! No doubt the nose panel would need to come back off, but that's quite acceptable and not a real big job. If the cab was back on, I can also start installing wiring etc... Any thoughts, folks?
|
Hi Tony,
Here is a very old photo (pre digital) of the engine and transmission coming out of my F15A chassis. I made a strong back out of RHS and angle and attached it by 8 bolts to the valve gallery where the intake manifolds sits to spread the load out. It was easy to fabricate and if you like, I can send a drawing of it. A series of holes for the shackle lets you lift the the engine and transmission together, or just the engine, keeping it level at all times. It used a front towing shackle from the truck to get the correct throat for the RHS width so that even saved a bit of money.
No doubt you could install it the same way with the cab on if you have a engine crane available with adequate outreach and capacity and shorten the lifting chain. The shop manual shows a similar arrangement using a special block and eyebolt inserted in the valve gallery.
I agree with Keith too. Probably best to leave the cowling off to give room to maneuver even though the shop manual indicates it can be done with it on.
Based on the number of cowlings I have seen with the top front crossmember cut out and the later factory mod of that front crossmember being a bolted in type I would say the manual diagram is not 100% correct and that part of the cowling gets in the way.
Cheers,