Taper at rear of the chassis starts roughly 2/3 to 3/4 back from the front spring hanger of rear spring. As it is, the top of rear spring hanger sits closer to top of rail, because of the amount of taper present. If the rear axle was located even further back originally, both front and rear hangers would be attached to an even shallower height of chassis, if taper continued. It would have been much further back too. As Mike has said, there is no visible set of holes that matches those of a former spring hanger location. If I'm right (will check today), the rear axle, if chassis was originally longer, must have been further back than the full lenght of the spring, or another set of holes would be evident....wouldn't it?
__________________
Ford CMP, 115" WB,1942 (Under Restoration...still)
Medium sized, half fake, artillery piece project. (The 1/4 Pounder)
|