View Single Post
  #5  
Old 11-04-16, 19:28
davestlaurent's Avatar
davestlaurent davestlaurent is offline
Registered User
 
Join Date: Jan 2016
Location: alma, quebec
Posts: 25
Default

i dont konw if i have a lot of chance or other so i put a video on my other post restoration of the lsvw. I noticed that the rear brake was worn abnormally and the bar that supports the board was floating two rear wheel then I have made ​​two more with a length of 1/8 longer. since the wafer supports are equally over the entire surface . The other problem I noticed was the system charge equalization that changes the hydrolic brake pressure according to the load. This caused a pressure loss and platelets were too low pressure in the back
__________________
WESTERN STAR (IVECO) LSVW
13 000 KM
Reply With Quote