[Ken Thomas]

Hi, could anyone in Australia (preferably in QLD) tell me where I could get access to an oil pan oil nozzle aiming tool & the dipper / trough checking tool. I would be prepared to buy, rent, borrow or beg. I have had the block rebored, the crankshaft ground, the main bearings line bored etc.& would not dare to take the risk of not doing this check. I have about six motors in pieces that I will have to pass on when I finish this one. I have 3 X C60s in pieces & some C15 as well. Once I have finished the motor I will start a ground up restoration on the C60. Pictures to follow Thanks, Ken