Hi Ken
You are the second person to ask this question this month, and as Mike suggest you do not need the actual tool.
Here is what I wrote up to help the last person who asked:
Have you checked the pictures on my web site? Here are the links
http://www.canadianmilitarypattern.c...nchevrolet.pdf This is the lubrication section of the manual. (Last guy to ask was working with out the manual.)
My testing and set up of the system using water.
http://www.canadianmilitarypattern.c...Page%20Two.htm The engine that I took the these photos of setting up the the nozzles now has over 10,000 miles so it must have worked. Be sure to watch the little video of the test. You will see that the stream of water is hitting the side of the pan right at the top of the pan edge. Also that the stream of water is hitting square with the truths. I checked the alignment with a clear strip of plastic, bolted to the block and drew lines for the edges and center of the scoops on the rod. Then bolted to pan using the matching bolt holes and water test the streams of water should hit the center of the scoop center lines. See attached photo Let me know if you need more information, think I have more photos of the process and tools that are not on the web page. Good luck.
With two people asking about this I try and see if I can find the original video and upload it to Youtube at higher resolution. I also made the tools shown in Figs 44-45-46 nothing special will dig them out and photo graph and you will see they are very simple and logical.
More questions please ask.
Cheers Phil