[Mike Cecil]

I purchased engine/transmission mounts from Macs: their part 64-17641, Motor Mount Kit, Large Hole (1-1/8), sub-part number 78-6038-S, is the entire mounting assembly, not just the insulator/rubber block - bolt, washers, split pin, rubber insulator, large cupping washer for the underside of the insulator, etc.

The rubber parts look to have the exact same dimensions as the ones I pulled off the GP and from the F15 I restored some years ago. I also checked the Ford Master Parts catalogue SNL G568 (Feb 29, 1944), and these insulators etc are common to most Ford passenger cars & trucks built for the US Army, including the Ford GP. It is listed as a part not exclusive to US govt vehicles.

The insulator, transfer case support for the GPW and GPA is listed as a 74-6038, and is also a part not exclusive to US Govt vehicles. I remember when I restored my GPW, I used an insulator sourced from Land Rover Australia - again, it had the exact same dimensions as those on the F15(Ford V8) and the GPW insulator I had removed during disassembly.

Mike