I'm about half way through the canvas curtain for rear window of my green truck.
Main part is finished, and the roll-up tabs on back are attached. The steel bar fits the bottom pocket OK. What isn't OK is my sewing. I sew like I weld. Terribly. Took second attempts on two stitch runs, both of which had to be unpicked stitch by stitch. It's a good incentive to get it right first time from then on!
Speaking of dodgy. Look at how straight the top steel piece isn't! It is original, and the joining of two short pieces is obvious. They had to elongate some holes to make it fit the piece behind it. Classic WW2 bodge, to 'keep em rolling'. The two tabs seen above photo are not attached yet. The canvas I used was very coarse and looks right. It did stretch in certain ways, and once that was anticipated I had a better time of working with it. Freys very easily though, so I was grateful that the plans for this piece (supplied by a good friend and fellow MLU chap) called for mostly double layer seams, one way or another.
The metal plates that sandwich the diagonal canvas tabs are painted and drying. I may place them next weekend, but will also be attending some duties in readiness for travelling to Bandiana early the following week.
Incidentally, I do believe I may have wasted my money on an industrial sewing machine, because this entire job was done on my Wifes standard duty Janome tabletop machine. There were seven layers of canvas in places, and her machine just chugged away without missing a beat. Can't imagine ever needing to sew eight or more layers in one place, so the Janome might get the job of stitching the sunshine roof cover in a few weeks time!