Looking back at earlier photos of Dave's engine rebuild, there seems to be a small casting that bolts to the face of the block, bottom dead centre at the front. The pulley assembly then fits over the shaft protruding through this small casting.
Is that casting original to the Lynx engine? If it is, everything should fit. If it is not the original casting, perhaps it is longer and causing the problem. The engine Dave is working on has a constant plane across the face of it, no recesses or protrusions for the water pumps, so if all the right pieces are attached to it, they should all line up. So now I am thinking a rogue part might be the problem.
David
|