What did you do with the boom crane? It looks to be the original crane as fitted to the F60L. Both the RAAF and the Army (mainly engineer units) used that crane type.
The original engine number, as Keith said, was also used as the chassis number of Aust assembled/built Fords, so that would be helpful in finding out its original identity/military registration number.
Nice project. Best of luck. The thread Tony pointed you to re valves just about provides everything you need to know or the options you have before you. As for pistons and crank shaft bearings, I used a later model crank shaft with two oil holes per journal, and fixed shell bearings rather than the original full-float type. Four ring pistons and 8BA con rods with fixed shell bearings. Also a crab-type distributor rather than the helmet type you already have. Balanced, it went like a train.
Mike
|