View Single Post
  #5  
Old 08-10-17, 14:42
Phil Waterman Phil Waterman is offline
Moderator
 
Join Date: Feb 2003
Location: Temple, New Hampshire, USA
Posts: 3,929
Default Along the inside of the driver side frame rail

Hi Eric & Jacques

I had been hesitate to wade in on this until Keith posted the photo confirming the routing along inside of the driver's side frame rail. All my experience has been with Chevy but you might find my experiences useful. (see below for some links)

First and most important be sure to watch the routing around the entire route to watch for rub points where the insulation can be damaged. Use lots of cable clamps to keep the harness where you put it. CMPS are poorly protected from shorts, result burning out harness, and anything near by, is a real threat.

My experience with burning out a section of brand new harness was in the congested area around battery cable, starter, master cylinder, speedometer cable, fuel line, and wiring harness they come together under the floor right under the driver.

Links to wiring information:
http://www.canadianmilitarypattern.c...nformation.htm

http://www.canadianmilitarypattern.c...%20Harness.htm

Hope this information is of some help, keep us posted on your progress.

Cheers Phil
__________________
Phil Waterman
`41 C60L Pattern 12
`42 C60S Radio Pattern 13
`45 HUP
http://canadianmilitarypattern.com/
New e-mail Philip@canadianmilitarypattern.com
Reply With Quote