try the dimension for a search...
Hi Harry
Was at a seal wholesaler today and they still prefer to search by OD/ID since numbers vary from manufacturer and over time..... once found they give you a choice of made by 'who' where (time) and/ or shipping cost.
You can probably figure out the ID easy enough but it will be a hell of a tight fit to measure the OD without taking your T case out....
Any body on the forum that has a 2 speed already taken apart for measuring....
I would suspect that the size for the two rods on the 2 speed and the one speed T case are the same...... need some time to read and compare in the parts manual..........
Mine where tight when I rebuilt my t case...... one of the few parts I did not have to change.
Good luck
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
|