I have taken the transfer case off and will need to take it apart to replace all the oil seals on the drive shafts. They all seem to leak at least a bit and since it is off I might as well do them all. The darn thing is quite heavy to carry....
Does anyone have the seal numbers for these? I am sure one of you out there has cross referenced the old number with new ones?
I have also taken the filter to a local metal fab shop to see what they can do to make me a set of tops for the filter cans. The fuel tanks I got with the truck are not bad but for this one where I plan to try driving it on the road I am having them make stainless fuel tanks for it. These will last as long as I own it and never give me issues with corrosion. A bit pricier than doing the sealant swish in the tank but a lifetime fix, so worth it to me. I have more CMP's with rustier tanks so these fuel tanks won't go to waste.
For the filter pumps does anyone have the experience of stripping them? Mine seem to be very well stuck and will not pump at all. I see they are all brass except the pin holding the handle which is solidly stuck in.
I will take them apart and try to replace the leather seals but since they likely won't ever pump water it is a moot point.
The hose for the pump and tank is a very heavy rubber 3/4 inch ID and 1 1/4 inch OD I am looking into finding that now, so that I can have the 30ft on hand to do it up once I get to that point.
Still no luck finding good solid old brass taps for the back where the troops get the water out.