[Bob Carriere]

First picture of the one I am currently measuring.... this isthe one we are currently measuring.....look at the difference with the old one I took apart years ago,,,,,

Second picture on the right....is the old set of pictures....taken when rebuilding my C15a with an early front axle using a R-Zeppa u-joint inside the egg cup.

Tird pic. of same T/i/ seens from underneath....... the one I am measuring in the top left has a large C clip holding the base inserted cap in place....( will undo one and document)
See the arrow pointing to the large recessed cotter pin holding the screwed on bottom cap....
Fourth pic..... see the arrows pointing tothe different holes indicating some adjustment is possible.....
One the Fifth....the guts of it all....... around ball at the bottom....two side insert....the spring that hols them when inserted inside.... the small coil spring that attached tothetwo holesshown on each of the two little pillow blocks....

See the next post