CASES, Spares, No. 1 Cdn No. 52 ZA/CAN/BR 2349
Final fills and sanding done on the grey case this morning and all the metal corner guards have been checked and reinstalled. only three of the eight needed a bit of careful hammer work to get them to sit flush on the case once again, and of those three, only one was quire bad. something had hit it on one side near the corner that really lifted that side off the wood. Fortunately I could just reach the raised bump on the inner side of the guard and work it flat.
So now both cases are ready to have all the metal bits final cleaned with the small steel wire wheel on the Dremel. Hopefully both cases will be done this step in the next week.
David
Last edited by David Dunlop; 27-06-23 at 01:16.
|