[Jordan Baker]

The turret gunners foot rest getting the full rebuild. It was in really great shape and just required a strip down, some minor welding and a repaint. The part was held in place by 4 rounded head slot screws that had seen better days. Access to the nuts was blocked by a frame cross member. I ended up using a Zip disk to cut off the heads of the screws. The downside to this was cutting a bit into the steel base just below the screw heads. So once the part was cleaned up I welded up the cut marks and ground them back down to make the mounting blocks flat again. As for cleaning up the part, it was given a quick needle scaler pass and then dropped into the citric acid bath. After 4 days I pulled it out and power washed it off. Pretty much all the left over paint came off and I had some pretty nice clean metal. It was given a spray of Zep degreaser, hosed off then finally sprayed with POR Metal Prep. Finally for painting I brushed on the POR15 and once slightly tacky it was over sprayed with the white paint.