[David Dunlop]

It took a little longer than I expected to get the Right Side Mounting Plate assembly zinc plated. I finally realized the zinc anode plate was very reduced in size from all the work it had been doing, and could not deliver the amount of zinc to the mounting plate at the cathode needed for a fast job. I ended up fitting three worn plate to the anode and modified the cathode assembly so the mounting plate was perpendicular in the container, parallel to the anode plate and as far away as possible from the anode.

Dry now and setting up for tomorrow.

The right side mounting plate is the one with the brass ground strap connecting the front screw assembly to the lower right front panel bracket, to properly ground the aluminum front panel plate of the coil assembly, so I am going to clean and plate the lower front left and right side front panel brackets tomorrow morning to get the grounding strap properly reinstalled and out of the way.



David