Quote:
Originally posted by rob love
Below is a photo of the real blanking board screw. With it are a couple of the origional lower panel thumb screws. All of these were buried for about 30 years in the Manitoba deepfreeze, and despite a bit of pitting, survived quite well.
It's a fairly simple screw, so it wouldn't be a whole lot to lathe out spares.
|
Interesting, they must have changed the mounting for the borad at some point. Ie mine slips on to a threaded shaft and then you put the nut on, which would be easier than holding the board and fishing around for a blind hole to screw the bolt in to.
I do have some of those butterfly bolts about the carrier, can't remember where they sit right now. Thanks Rob.
Sean