Hi Mike
By saying the "mk1 seat backrest" do you mean the backrest for the driver. If so it is 14 1/2" wide and 25 1/2" long. I used plywood that is slightly over 3/8" thick. These measurements are taken off of my original.
I do not have any dimensions for the "board blanking". I would just make slightly larger then the hole in the division plate. Why do you need dims on this, I thought you made one out of expanded mesh steel?
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
|