tranny
Hi Bob
After lots of breakfree or similar product I just pushed down on the assemly at the bottom of the shifter shaft and twisted it counter clockwise. I used a big open jaw pair of plyers to do the twist while I pushed down with my fingers. only has to turn about half an inch and then the spring should push it up. The pliers should not squeeze to tight as it is a flimsy piece.
I see you have a broken tail shaft like I had on three of my 4 transmissions, make sure you read a back issue of convoy or an old post on this forum for the fix to prevent it from happening again..Hint, "the Ring"
Harry Moon
|