Lever arm and plunger detail.
The spring retaining pin is not identified in my picture because it is not listed in the parts manual. You can just make it out in my picture at the top of the spring.
To make these I bought some compression springs that fit the plunger at Home Depot. I streched them out to make them into extension springs and then cut them to the needed length. I then screwed them onto to the plunger after I had installed the retaining pin.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
Last edited by Jordan Baker; 09-01-07 at 06:13.
|