It’s been a while since I’ve worked on the Otter. This afternoon I decided to tackle another of the original fenders. This one had taken a beating with entire fender flare rolled into and under the upper surface. The original bend crease was still there but a new edge had been rolled into it. This made it quite the challenge to get the upper surface flat again and not loose the original bend. Below are two pictures of what it looked like when I got the Otter.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
|