View Single Post
  #2  
Old 04-11-21, 17:13
rob love rob love is offline
carrier mech
 
Join Date: Feb 2003
Location: Shilo MB, the armpit of Canada
Posts: 7,276
Default

Best thing I have found for cutting rubber is a straight edge and razor knife. That is assuming it does not have the little pieces of steel belting in them. Cut once, bend it a bit, cut again, and repeat until it is done. And of course, use a brand new razor blade.
Anything like a saw or grinder disc is going to make an incredible amount of dust or clog up as the heat turns the rubber to goo. Perhaps running water on the cut like you would with cement might help.
Reply With Quote