Bob,
Thankyou!
You will make both my Christmas list & Last Will if you find something suitable.
I'm off to town now, for a bearing puller. I can't seem to get rear hub out of axle. Axle shaft is out, as is the cone bearing race, but not inner cone. Looking though the manual, I don't understand how this may prevent hub removal, but since it says remove it.......i'll remove it!
Hub can move in/out about 1/8in but no further. Made makeshift hub puller from chain/dog attached to the axle bolt round plate & attached it to pull with tightening the 'dog' but no good & i'm not prepared to put great force onto it. Hub seems to strike something inside after the 1/8in movement.
Enough grease inside there to choke a donkey & I can't get a good look in there.
If at first you don't succeed, read another manual!!!!