Thread: hub seal
View Single Post
  #2  
Old 08-01-06, 07:03
Phil Waterman's Avatar
Phil Waterman Phil Waterman is offline
Super Moderator
 
Join Date: Feb 2003
Location: Temple, New Hampshire, USA
Posts: 3,914
Default Speedy Sleeve

The solution to this problem is pretty straight forward and not as expensive as you might think. Don't know the sources down your way but here is a Canadian/US company that I've had good luck with. http://www.motionindustries.com/moti.../mi/motion.jsp

So far I've used Speedy Sleeves in the following CMP applications, engine front and rear seal on the crank , transmission tail shaft, transfer case all of the input and out put shafts. And they do have sleeves large enough for the front hubs.
__________________
Phil Waterman
`41 C60L Pattern 12
`42 C60S Radio Pattern 13
`45 HUP
http://canadianmilitarypattern.com/
New e-mail Philip@canadianmilitarypattern.com
Reply With Quote