View Single Post
  #105  
Old 29-07-13, 23:28
Alex van de Wetering Alex van de Wetering is offline
Moderator
 
Join Date: Mar 2003
Location: Hoofddorp, The Netherlands
Posts: 2,670
Default

The thing that had been bugging me from the beginning was that one of the studs in the master cylinder casting was not really screwed in far enough.....So, took the master cylinder off again and with help of two nuts and a spanner I tried to screw it in further. I didn't even put the thing in a vice, but than it was "snap".....cracked the casting! I unscrewed the stud and found the lower half of the hole was filled with black crud....maybe even from the factory??

Not a happy ending this weekend, I'm afraid....and really don't know if this thing can be saved or not.

Alex
Attached Thumbnails
Master6.jpg   Master7.jpg   Master8.jpg   Master9.jpg  
__________________
Chevrolet C8 cab 11 FFW
BSA Folding Bicycle
Reply With Quote