[Bob Moseley (RIP)]

Hi all - have obtained prices for manufacture of various components so sit down whilst reading. These are from a very reliable manufacturer who is also a military vehicle restorer so understands the needs and budgets of restorers. These prices will also give you a greater appreciation of the value of the parts you have, if they are any good, or what you could expect to pay for their replacement. These prices are for small runs and include the setup charges so obviously the more made at one time the less expensive the exercise could be. If you need any of these contact me ASAP as the manufacturing lead time is two weeks and I have to get these done to complete Phoenix in time for Corowa.

Axles with the correct thread - $185 (inc) each.

Castellated nuts with the correct thread that will also fit your axles - $48 (inc) each.

Bearing retaining rings - $38 (inc) each.

Grease retaining washer - $7 (inc) each.

35 tooth sprocket - $980 (inc) each but if I do a run of 10 (5 sets) the cost comes down to $920 (inc) each a saving of $60 each.


Bob