Quote:
Originally Posted by Mike Kelly
I have been wondering if a modern hub seal can be fitted to the rear axle hubs on the CS8 . After looking at how the hub is designed - in the case of the CS8, I feel it would be a difficult conversion . I am not certain about how the 4x4 hub is set up but it appears to be similar to the CS8 rear hub, maybe you and Paul can come up with a solution .
|
It looks like a 3 1/2 x 4 7/16 x 3/8 conventional seal could fit instead of the felt seal and it's retainer ring, but the seal lip would only just bear on the journal of the distance piece.
Machining the flange on the distance piece could allow the seal to move out a bit but then it may be not far enough inside the hub bore.
It would be a gamble to alter a distance piece to find it did not work.
If I could find some new felt rings I would stick to that system.
Terry.