Have used both wood blocks and truck stands and to be honest prefer the stands for carriers, easier to set correctly etc I use 5T stands as a minimum ..... over 10T Armour go the wood blocks if you don't have specific hull frame stands. Most importantly however- do not support the weight on the floor plate. All stands/blocks should be on the corner's of the hull, where the side meets the floorplate, the weight bearing ability of the side plates is far better than the floorplate. I use a frame spot welded to this location to move hulls in the workshop, when the frame is cut off, it leaves a couple of weld dags that locate the stands nicely, and no slipping issue. Same locations should be used when jacking also FYI- sliding the jack under the floor is not the best way to go.
Rob
|