CMp front fender brace cab 12
A few pictures worth many words....
Full view
focus on reworked end
offset
location on arch
Note..... the pen is inserted where the bolt would go into the arch, the fender then the airvent sheet metal. The hole is not round but cut out to a U shape allowing some flexibility to the fender.
The end that is flattened is about 1/4 thick...... flat area 1 1/4 long x 1 inch wide....curvature of offset 2 inches.
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
|