The next issue was what to do with the recoil rods which were now sticking out past the muzzle. They were absolutely solid, and with the pitting on them I suspect they were never going to be made to work again anyway. It is certainly not my intention to make this into a working gun.
I simply torched them ff close to the cylinders. The center cylinder had been left open for all those years, and water had collected inside of it. It froze and cracked the bottom of the cylinder, possibly mis-shaping the whole recoil mechanism. I suspect that was why it was so hard putting the sleigh back to the proper position.
In the last photo you can see where I have installed a set of the STA 10.50-16 tires. They look a little baloonish but at the same time the tread doesn't look out of place either.
Last edited by rob love; 02-11-16 at 15:26.
|