For the master cylinder outlet end cap, I believe I've seen them aftermarket but don't remember where right now. I don't have the parts book with me but if you have it, a search on the part number has frequently produced results for me when I haven't been thinking the same name for a part as the seller.
For the gas/accelerator/throttle pedal, there were both rubber covered and bare metal used according to the parts book. The rubber covered one was a civilian part, off the shelf. I had luck finding one on ebay but don't remember what it was sold as fitting... so that's not a lot of help to you. The two pedals mount in the same way to the floor but need different 1st parts of the linkage. (rubber pedal takes a ball end and the metal a 90 degree bend and cotter pin)
Last edited by Grant Bowker; 16-11-17 at 14:28.
|