Spent most of the day Friday working on the box. The two wheel wells needed some work done to them. Two end panels had suffered from some metal rotting. New pieces were cut and the old ones were cut out. I was able to re-use three of the loops that are welded on these panels. The fourth one was made.
Saturday was spent going to Cleveland to check out the MVPA National convention. Had a great time.
Today's plan was to get the new angle iron sections welded onto the floor and also get the front panel tacked in. I did manage to get this done even with the weather not cooperating. Setting up three times and bringing my tools and welder back inside three times was a bit of a pain.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
|