Just thought I would ad this little tip that worked for me. Was talking with my friend today and the topic came up regarding the fuse that is for the lights and goes in the separate holder with cover inside the dash panel. As we were able to get new ones but the fuse section did not have the wire on the board. As I was looking for something totally different I stumbled upon a fuse that was used in my Saturn under the hood and it looked very close in size as the original unit. The fuse was rated at 30 amps which I thought was too much for the headlights/tail lights so I took it and snipped in the middle of the fuse link as there was a small hole there from factory so I thought that if the whole fuse link was 30A that half of it would be around 15A. After the snip I just wrapped some electrical tape around it so no possibility of shorting out on anything
