View Single Post
  #3  
Old 04-11-21, 18:04
Mike Cecil Mike Cecil is offline
Registered User
 
Join Date: Jun 2006
Location: Colbert, Washington, USA
Posts: 2,230
Default

I recently had to cut some 6.00-16 tyres from wheel rims. I used a Sawzall with a demolition-toothed blade to cut out a big 'U' in the rubber down to the steel wires/belt, then an angle grinder with a metal cutting blade to nip through the steel part once I prised it just clear of the wheel rim using two large screwdrivers. Worked well: some mess of rubber granules from the saw, and a little acrid smoke from the grinder, otherwise no problem at all.

Unless you want a clean edge, the Sawzall worked well.

I've used a non-slip tape on steps and it works really well.

Like this: https://www.amazon.com/Slip-Guard-No.../dp/B01HQXNBHW

Mike

Last edited by Mike Cecil; 05-11-21 at 03:31.
Reply With Quote