View Single Post
Old 19-05-12, 11:58
Alex van de Wetering Alex van de Wetering is offline
Registered User
Join Date: Mar 2003
Location: Hoofddorp, The Netherlands
Posts: 2,246

I first made a template from cardboard and than transferred it to steel. Forming the replacement bits was largely a matter of trial and error with a hammer and wooden blocks. The crossmember is slightly angled towards the front of the frame, so the replacement bits left and right are mirrored. I cleaned the inside of the crossmember as much as possible, treated it ith Fertan and coated it in primer, before welding the new bits in.
Attached Thumbnails
Cro1.jpg   Cro2.jpg   Cro3.jpg   Cro4.jpg   Cro5.jpg  

Chevrolet C8 cab 11 FFW
BSA Folding Bicycle

Last edited by Alex van de Wetering; 19-05-12 at 12:06.
Reply With Quote