Ok thanks all for the advice on the clutch fork spring. There is a hole on the master cylinder metal mount that will work for the other end of the spring.
This afternoons project was to work on the exhaust pipe and muffler. I picked up a NOS muffler and exhaust pipe awhile back. However this pipe must have been for longer chassis as I had to cut out a section so the muffler would sit on the frame mount for it.
One question I do have, What is supposed to be used to seal the gap between muffler end and the exhaust pipe where the pipe slides into the muffler? Hopefully I have explained that clear enough to make sense.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
|