Main event
For some reason I have been dreading the engine. I think mainly because I was dreading making a costly mistake.
Anyway... now I have made a start, I am really enjoying doing the rebuild.
Had an original engine stand (which is very well made) and it has been put into good use.
Valves done, clearances done (about 8 removals of each lifter to get them right). Solid lifters used. Egge is the brand of the stuff I was sent. Did not want to drill holes in the block cause I was worried I might clutz that up.
One piece guides and colletts. Original keepers for the guides used. Those mysterious O-Rings that came in the kit were put in - on a second go of course.
__________________
Pax Vobiscum.......may you eat three meals a day & have regular bowel movements.
Last edited by Ganmain Tony; 13-06-20 at 06:38.
Reason: More blab
|