Quote:
Originally Posted by sth65pac
I removed the temporary brace and the 1/4" rivet misalignment has become about 1/16" ordered additional rivets but they are too small so I'll have to make up some with steel rod.
Cheers,
Ian
|
Hi Ian,
Will look forward to reading how you form the rivet heads for your project.
My same rear crossmember has some wastage on it and a long term project is to someday replace that with a good donor crossmember I salvaged.
I saved one of the original donor crossmember rivets as a sample as per attached photo.
The dimension may be out a bit due to deformation as the rivet is driven but that was the diameter (inches) of the shank of the rivet as miked after removing all rust.
If you, or anyone else, ever find a supplier of the correct round head rivets please let me know.
Cheers,