View Single Post
  #21  
Old 18-06-21, 00:09
Chris Suslowicz Chris Suslowicz is offline
Junior Password Gnome
 
Join Date: May 2007
Location: England
Posts: 814
Default

Hi Petr,

If Post #18 in this thread is your carrier, then it has the mounting hardware for a couple of tables, one to take the chorehorse carrier and the other with the table clamps for what is probably a variation of Carrier No.25.

How wide is the space where the mounting bars are fitted?

I've measured my Carrier No.25 and it is 25-inches (63 cm.) across.

I believe that with a suitable mounting board and table clamps, my set would be a "drop in" fit, complete with the standard waterproof cover, and that it is likely to be correct for the Mark III Universal Carrier (with WS19 Mark 3).

If that is the case I can work out the complete parts list for the carrier.

(I have been looking for photographs on the internet and am amazed at the number of Tamiya kits where people have stuck an 'A' set aerial into the 'B' set aerial base!)

Oh, and you will need three Aerial Base No.10 Mk.2 and one Aerial Base No.9 plus mounting No.1 for the carrier! (No.9 base behind the commander/gunner, one Base No.10 at front and rear, and the third one on the plate with variometer and Control Unit No.2.)

Best regards,
Chris.
Reply With Quote