Quote:
Originally Posted by Robert Bergeron
Question:
How are the two standard CMP seats held down on the special bracket that's bolted to the floor of the box ?
|
Here's an alternate solution that uses only existing CMP seat parts. The clips holding the seat base to the riser are : large part (green) - standard Cab 13 hold down bracket and small part (also green) stop to limit seat travel (normally mounted to the two holes above and to the right of the clip in the photo. When I grabbed the parts off the shelf for the photos I thought the small brackets were also Cab 13 seat hold down clips but have since changed my mind (but I am convinced the hold down clip would work). If you don't have extras sitting around, they should be easy enough to make using the clips in your cab as patterns. While taking the photos I realized that one of the riser feet needed replacement.