View Single Post
  #230  
Old 12-09-19, 23:40
Alex van de Wetering Alex van de Wetering is offline
Moderator
 
Join Date: Mar 2003
Location: Hoofddorp, The Netherlands
Posts: 2,670
Default

Now for the left side fender....This one was worse. I started by trying to bend it back into shap as much as I could. Than welded in a strip along the edge where it is bolted to the cabin. This time is cut out a larger section of the fender....right to the nicely rounded edge on the front and side of the fender. This was a better approach than what I did with the other fender, as it gives a much nicer result......less risk of a peak where the new metal is welded to the old.

Holes for the fender supports and headlights were drilled after patch panels were all done.

Alex
Attached Thumbnails
IMG_7242.JPG   IMG_7255.JPG   IMG_7259.JPG   IMG_7262.JPG   IMG_7424.JPG  

__________________
Chevrolet C8 cab 11 FFW
BSA Folding Bicycle
Reply With Quote