[Jacques Reed]

Good Day,

While sorting out the speedometer cable length and route I thought it would be a good time to sort out the handbrake lever bracket.

The parts manual shows washers *C351399S, 0.40" ID x 0.18 thick between the sector and the transmission bracket. I discovered a long time back that these washers move the arm further outboard, and in doing so moves the handbrake rod away from the transmission crossmember where it passes through it.

I used a pack of about 4 washers at each bolt to achieve this but it was a right pain to get everything lined up and not drop any of them on the deck.

So instead, I just made a spacer out of 1/4" flat bar as shown. It is a lot easier to handle and gives better support to the sector. Sometime you just have to deviate from original to make things work better.

As a matter of interest I've had three of these handbrake assemblies and all three were missing the spacer washers. Just shows some of the many small bits that goes missing over the years.

Cheers,