Tear down of the generator continued today. Everything has been disassembled and the major parts parts sandblasted. The commutator was cleaned up on a lathe. The field coils will be re wrapped as well. All of the small screws are being soaked in parts cleaner then in evaporust to clean them up. I'll be ordering a new fully sealed bearing for the drive end. I just need to find a couple of smaller bits and I should be good to go again.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
|