View Single Post
  #36  
Old 23-03-06, 03:42
Bob Carriere Bob Carriere is offline
Moderator
 
Join Date: Mar 2003
Location: Hammond, Ontario
Posts: 5,191
Default Ditto...

Hi Phil

Did the same thing with John Stuart in Stoney Creek and about the same price in CDN dollars.... he is well known in hot rod circles and does mostly industrial/commercial rebuild.......

One question.... some old master cyl. have bare steel surfaces but on a few old ones.... including the master from Rob's HUP it had a brass sleve insert. Where they doing brass insert years ago when rebuilding or where they made like that form the factory.

In Rob's case he managed to get a rebuild kit and we buffed the inside of the master cyl using a home made mop fabricated with 3M pads donuts cut and mounted on a 1/4 inch bolt. Once installed in the drill press at slow rpm it polished the inside to a nice shin.

Once the snow melts a little more I will tackle the linkage for the power booster...... will check the frame and if too far gone may just cut off the side and use it as a mock up for the duplication and trial fitting.....

Hang in there.

Bob C
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
Reply With Quote