View Single Post
  #398  
Old 17-10-20, 20:50
David Dunlop David Dunlop is offline
Registered User
 
Join Date: Feb 2006
Location: Winnipeg, MB
Posts: 3,384
Default MAINSPRINGS, Cowl Fastener ZA/CAN 4713

These are the receptacles into which the Airloc Studs for the upper panel of the 52-Set Receivers lock. Countersunk, tubular rivets are used to hold them in place in those two locations.

These fasteners are also used in the top and side rails of the Carriers No. 4 ( four in each location) to which the Coil, Aerial Tuning Box is fitted. In these two locations the fasteners are spot welded in place and would be very tough to replace.

The right side fastener on one of my receivers is broken and needs to be replaced and I was having a hard time finding the receptacles. Finally, the light bulb lit with regards to the word 'Cowl' and I started searching on vintage aircraft restoration sites. Bingo! there they were, and still being referenced by their Airloc Stock Number 99833P-130.

No luck yet finding the replacement pins needed for the Airloc studs themselves, or the equivalent for the Shakeproof Cowl Fasteners. Critical bits as the pins cannot be reused once removed from a stud.

David
Attached Thumbnails
WS No. 52 MAINSPRINGS, Cowl Fastener.JPG  
Reply With Quote